50 ohm driver amplifier

These driver amplifiers include output powers from 15 dBm up to approximately 1 watt while covering various frequencies, bandwidths and gain levels. Most designs are internally matched to 50 Ohms with designs that include both bare die and packaged parts.  · U can use a 50 ohm driver (amplifier) and 50 ohm tx line termination. Sep 1, #6 G. goodboy_pl Full Member level 5. Joined Messages Helped 16 Reputation 32 Reaction score 15 Trophy points 1, Activity points 3,  · However, I want the output to drive 50 cable and the LMC does not have enough output current. I have been searching for various op amps that can act as a driver for 50 ohms such as BUF, LMH, and OPA A 5 volt signal into 50 ohms is mA so I need at least mA output current for the buffer.

Hi, I'm looking for dual channel buffer/amp with high input impedance to drive single ended 50 ohms load from 1kHz to 20MHz. These driver amplifiers include output powers from 15 dBm up to approximately 1 watt while covering various frequencies, bandwidths and gain levels. Most designs are internally matched to 50 Ohms with designs that include both bare die and packaged parts. Suitable for Doherty Amplifiers and BTS Transmitters 5 V Single Supply, mA Quiescent Current SOT Package 50 Ohm Operation with Minimal External Matching Table 1. Load Pull Performance (1) Characteristic Symbol 9MHz 21MHz 35MHz Unit Maximum Available Gain MAG dB.

1 ມິ.ຖ. – GHz Differential to Single-Ended Gain Amplifier in a 2 x 2 mm2 LGA package, with Ω input and 50 Ω output impedances. 3W Power Amplifier Module GHz, 75 ohm, 5V RF Amplifier 50 - MHz, Driver Amplifier - GHz, E-Band Power Amplifier, 71 - 86 GHz. −3 dB bandwidth: MHz, G = +5, RLOAD = 50 Ω Selectable quiescent current: 1 mA to mA/amplifier while driving low impedance loads.